Migration from ar71xx to ath79 included changes to the ethernet/switch
driver for the target. This introduced a peculiar issue where
eth0 and eth1 are swapped for several devices. Most of the relevant
cases were already covered in 1cf4d762ff ("treewide: move devices
from ar71xx to ath79").
This switch also affects the Nanostation M, where the PoE-in port
is now eth1 und the PoE-out port is eth0. However, no action was
taken in the referenced patch, as nobody was aware of it then.
Since the Nanostation M is a two-port device, which we cannot
implement properly so far, it was implemented as a one-port with
the "primary" PoE-in port so far. This was broken by the ath79
introduction and is now fixed in this patch by using the one-port
setup on eth1. That way, the PoE-in port can now be switched by
ETHMODE as usual again.
Note that custom script, e.g. to set up the second port, need to
be adjusted manually, as that one is eth0 now.
Fixes: 1cf4d762ff ("treewide: move devices from ar71xx to ath79")
Fixes: #109 (gitea)
Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>
We use the one-port implementation also on two-ports like the
Nanostation M. Therefore, hard-coding eth0 in configurenetwork
will break if the port implemented for the one-port setup
(SWITCHDEV/WANDEV) is not eth0.
Just use SWITCHDEV instead, like done for the rest of the one-port
setup.
Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>
Adrian Schmutzler