openwrt/target/linux/kirkwood/base-files/etc/board.d
Pawel Dembicki 3843c641d8 kirkwood: add support for Ctera C200 V1 NAS
2-Bay NAS - maximum two 3.5" Harddisks

Hardware:
  - SoC: Marvell 88F6281-A1 ARMv5TE Processor 1.2GHz
  - Ram: 512MB (4x Nanya NT5TU128M8GE-AC)
  - NAND Flash: 256MB (Samsung 216 K9F2G08U0C)
  - Lan: 1x GBE (Marvell 88E1116R-NNC1)
  - Storage: 2x SATA HDD 3.5" Slot
  - USB: 2x USB 2.0 port
  - Console: Internal J3 connector (1: Vcc, 2: Rx, 3: Tx, 4: GND)
  - LEDs: 13x GPIO controlled
  - Buttons: 2x GPIO controlled

Known issues:
  - Buzzer is unused due lack of proper driver

Installation:
  - Apply factory initramfs image via stock web-gui.
  - Do sysupgrade to make installation complete.

Back to stock:
  - OpenWrt rootfs partition use unused space after stock firmware.
  - Full revert is possible.
  - Login via ssh and run: ctera_c200-v1_back_to_factory

Signed-off-by: Pawel Dembicki <paweldembicki@gmail.com>
Reviewed-by: Sungbo Eo <mans0n@gorani.run>
[apply sorting to device recipe]
Signed-off-by: Sungbo Eo <mans0n@gorani.run>
2021-12-04 09:39:11 +09:00
..
01_leds treewide: remove execute bit and shebang from board.d files 2021-03-06 11:30:06 +01:00
02_network kirkwood: add support for Ctera C200 V1 NAS 2021-12-04 09:39:11 +09:00
03_gpio_switches treewide: remove execute bit and shebang from board.d files 2021-03-06 11:30:06 +01:00
05_compat-version kirkwood: increase kernel size of Linksyses 2021-09-13 18:36:15 +02:00