mirror of
https://git.openwrt.org/openwrt/openwrt.git
synced 2024-06-26 09:37:29 +02:00
ramips: add support for ipTIME A3004T
ipTIME A3004T is a 2.4/5GHz band router, based on Mediatek MT7621. Specifications: - SoC: MT7621 (880MHz) - RAM: DDR3 256M - Flash: NAND 128MB (Macronix NAND 128MiB 3,3V 8-bit) - WiFi: - 2.4GHz: MT7615E - 5GHz : MT7615E - Ethernet: - 4x LAN - 1x WAN - USB: 1 * USB3.0 port - UART: - 3.3V, TX, RX, GND / 57600 8N1 Installation via web interface: 1. Flash initramfs image using OEM's Recovery mode 2. Boot into OpenWrt and perform sysupgrade with sysupgrade image. Revert to stock firmware: - Flash stock firmware via OEM's Recovery mode How to use OEM's Recovery mode: 1. Power up with holding down the reset key until CPU LED stop blinking. 2. Set fixed ip with `192.168.0.2` with subnet mask `255.255.255.0` 3. Flash image via tftp to `192.168.0.1` Additional Notes: This router shares one MT7915E chip for both 2.4Ghz/5Ghz. radio0 will not working on 5Ghz as it's not connected to the antenna. Signed-off-by: WonJung Kim <git@won-jung.kim> (added led dt-bindings) Signed-off-by: Christian Lamparter <chunkeey@gmail.com>
This commit is contained in:
WonJung Kim
Christian Lamparter
parent
482a7e23a4
commit
2dde2416e1
172
target/linux/ramips/dts/mt7621_iptime_a3004t.dts
Normal file
172
target/linux/ramips/dts/mt7621_iptime_a3004t.dts
Normal file
|
|
@ -0,0 +1,172 @@
|
|||
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
|
||||
|
||||
#include "mt7621.dtsi"
|
||||
|
||||
#include <dt-bindings/gpio/gpio.h>
|
||||
#include <dt-bindings/input/input.h>
|
||||
#include <dt-bindings/leds/common.h>
|
||||
|
||||
/ {
|
||||
compatible = "iptime,a3004t", "mediatek,mt7621-soc";
|
||||
model = "ipTIME A3004T";
|
||||
|
||||
aliases {
|
||||
led-boot = &led_cpu;
|
||||
led-failsafe = &led_cpu;
|
||||
led-running = &led_cpu;
|
||||
led-upgrade = &led_cpu;
|
||||
};
|
||||
|
||||
leds {
|
||||
compatible = "gpio-leds";
|
||||
|
||||
led_cpu: led-0 {
|
||||
label = "amber:cpu";
|
||||
color = <LED_COLOR_ID_AMBER>;
|
||||
function = LED_FUNCTION_CPU;
|
||||
gpios = <&gpio 18 GPIO_ACTIVE_LOW>;
|
||||
};
|
||||
|
||||
led-1 {
|
||||
color = <LED_COLOR_ID_AMBER>;
|
||||
function = LED_FUNCTION_WLAN;
|
||||
function-enumerator = <0>;
|
||||
gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
|
||||
linux,default-trigger = "phy0radio";
|
||||
};
|
||||
|
||||
led-2 {
|
||||
color = <LED_COLOR_ID_AMBER>;
|
||||
function = LED_FUNCTION_WLAN;
|
||||
function-enumerator = <1>;
|
||||
gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
|
||||
linux,default-trigger = "phy1radio";
|
||||
};
|
||||
};
|
||||
|
||||
keys {
|
||||
compatible = "gpio-keys";
|
||||
|
||||
reset {
|
||||
label = "reset";
|
||||
gpios = <&gpio 4 GPIO_ACTIVE_LOW>;
|
||||
linux,code = <KEY_RESTART>;
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
&nand {
|
||||
status = "okay";
|
||||
|
||||
partitions {
|
||||
compatible = "fixed-partitions";
|
||||
#address-cells = <1>;
|
||||
#size-cells = <1>;
|
||||
|
||||
partition@0 {
|
||||
label = "u-boot";
|
||||
reg = <0x0 0x80000>;
|
||||
read-only;
|
||||
};
|
||||
|
||||
partition@80000 {
|
||||
label = "config";
|
||||
reg = <0x80000 0x20000>;
|
||||
read-only;
|
||||
};
|
||||
|
||||
factory: partition@a0000 {
|
||||
label = "factory";
|
||||
reg = <0xa0000 0x20000>;
|
||||
read-only;
|
||||
|
||||
compatible = "nvmem-cells";
|
||||
#address-cells = <1>;
|
||||
#size-cells = <1>;
|
||||
|
||||
macaddr_factory_4: macaddr@4 {
|
||||
reg = <0x4 0x6>;
|
||||
};
|
||||
|
||||
macaddr_factory_8004: macaddr@8004 {
|
||||
reg = <0x8004 0x6>;
|
||||
};
|
||||
};
|
||||
|
||||
partition@140000 {
|
||||
label = "firmware";
|
||||
reg = <0x140000 0x7e40000>;
|
||||
|
||||
compatible = "fixed-partitions";
|
||||
#address-cells = <1>;
|
||||
#size-cells = <1>;
|
||||
|
||||
partition@0 {
|
||||
label = "kernel";
|
||||
reg = <0x0 0x400000>;
|
||||
};
|
||||
|
||||
partition@400000 {
|
||||
label = "ubi";
|
||||
reg = <0x400000 0x7a40000>;
|
||||
};
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
&gmac0 {
|
||||
nvmem-cells = <&macaddr_factory_4>;
|
||||
nvmem-cell-names = "mac-address";
|
||||
mac-address-increment = <(3)>;
|
||||
};
|
||||
|
||||
&switch0 {
|
||||
ports {
|
||||
port@0 {
|
||||
status = "okay";
|
||||
label = "wan";
|
||||
nvmem-cells = <&macaddr_factory_4>;
|
||||
nvmem-cell-names = "mac-address";
|
||||
mac-address-increment = <(1)>;
|
||||
};
|
||||
|
||||
port@1 {
|
||||
status = "okay";
|
||||
label = "lan4";
|
||||
};
|
||||
|
||||
port@2 {
|
||||
status = "okay";
|
||||
label = "lan3";
|
||||
};
|
||||
|
||||
port@3 {
|
||||
status = "okay";
|
||||
label = "lan2";
|
||||
};
|
||||
|
||||
port@4 {
|
||||
status = "okay";
|
||||
label = "lan1";
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
&pcie {
|
||||
status = "okay";
|
||||
};
|
||||
|
||||
&pcie0 {
|
||||
wifi@0,0 {
|
||||
compatible = "mediatek,mt76";
|
||||
reg = <0x0000 0 0 0 0>;
|
||||
mediatek,mtd-eeprom = <&factory 0x0>;
|
||||
};
|
||||
};
|
||||
|
||||
&state_default {
|
||||
gpio {
|
||||
groups = "i2c", "jtag", "wdt";
|
||||
function = "gpio";
|
||||
};
|
||||
};
|
||||
|
|
@ -766,6 +766,23 @@ define Device/iptime_a3004ns-dual
|
|||
endef
|
||||
TARGET_DEVICES += iptime_a3004ns-dual
|
||||
|
||||
define Device/iptime_a3004t
|
||||
$(Device/dsa-migration)
|
||||
$(Device/uimage-lzma-loader)
|
||||
BLOCKSIZE := 128k
|
||||
PAGESIZE := 2048
|
||||
FILESYSTEMS := squashfs
|
||||
KERNEL_SIZE := 4096k
|
||||
IMAGE_SIZE := 129280k
|
||||
UIMAGE_NAME := a3004t
|
||||
UBINIZE_OPTS := -E 5
|
||||
IMAGE/sysupgrade.bin := sysupgrade-tar | append-metadata
|
||||
DEVICE_VENDOR := ipTIME
|
||||
DEVICE_MODEL := A3004T
|
||||
DEVICE_PACKAGES := kmod-mt7615e kmod-mt7615-firmware kmod-usb3
|
||||
endef
|
||||
TARGET_DEVICES += iptime_a3004t
|
||||
|
||||
define Device/iptime_a6ns-m
|
||||
$(Device/dsa-migration)
|
||||
IMAGE_SIZE := 16128k
|
||||
|
|
|
|||
|
|
@ -58,6 +58,7 @@ platform_do_upgrade() {
|
|||
dlink,dir-2660-a1|\
|
||||
dlink,dir-853-a3|\
|
||||
hiwifi,hc5962|\
|
||||
iptime,a3004t|\
|
||||
jcg,q20|\
|
||||
linksys,e5600|\
|
||||
linksys,ea7300-v1|\
|
||||
|
|
|
|||
Loading…
Reference in New Issue
Block a user