Flashing instructions:
The factory image needs to be uploaded via the OEM firmware GUI.
Notes:
The device is implemented as two-port in OpenWrt, i.e. it has
eth0/eth1 interfaces without switch setup. As our firmware currently
does not support that, this uses a switch setup with one port for
LAN.
Signed-off-by: Fabian Eppig <fabian@eppig.de>
[add commit message, apply alphetic sorting in bsp, remove config
changes apart from adding CONFIG_TARGET_DEVICE]
Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>
OpenWrt only builds and installs a packet for each architecture.
If a package is already fully built and installed for a architecture,
it is not rebuilt.
Because we have two different BSPs building two different targets (BOARDs)
using the same architecture (ath79 and ar71xx, mips), the fff-network package
is not reinstalled when switching between those.
However, we have defined an install step, which copies the necessary network
files seperated by board. But because the package is not rebuilt when switching
targets, the wrong network files might be present in the package.
To resolve this issue, the network files are now seperated by ARCH instead of
the target (i.e. the BOARD variable).
Signed-off-by: Fabian Bläse <fabian@blaese.de>
Acked-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>
Acked-by: Robert Langhammer <rlanghammer@web.de>
[bump PKG_RELEASE]
Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>
Fabian Eppig
Fabian Bläse