forked from freifunk-franken/firmware
The V2 firmware requires initialization of the WiFi interfaces by a hood file. If a one-port (or two-port) device is isolated, it won't get this information from other WiFi nodes (w2sta mode). In addition, it cannot be connected to the internet, as this would require the port to be in WAN mode. It is also not possible to connect a client device for configuration, since WiFi is not configured and the LAN port is in BATMAN mode. To enable configuration of an isolated one-port/two-port device, this patch thus changes the default port config to CLIENT, so the user can choose the desired configuration more easily. For two-port, we will have one port WAN and the second port CLIENT. Fixes #110 Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de> Reviewed-by: Harald Thuemmler <int@bnhof.de> Reviewed-by: Fabian Bläse <fabian@blaese.de>
31 lines
1.2 KiB
Plaintext
31 lines
1.2 KiB
Plaintext
################
|
|
## This file is used to configure the behavior of network interfaces
|
|
## if the routers interfaces differ from the standard WAN+4LAN-Ports
|
|
## +2Wireless APs.
|
|
## If you want to change their behavior, you should edit the file
|
|
## /etc/network.config
|
|
## After that you have to reboot the router with following command.
|
|
#reboot
|
|
#
|
|
### The canonical syntax of this file is:
|
|
#SPECIFIER="MODE"
|
|
### MODES
|
|
## Generally there are 3 operating modes for network interfaces in fff.
|
|
#BATMAN: The interface is used to mesh with other fff-nodes
|
|
#WAN: The interface is used to connect to supernodes via vpn and
|
|
# ordinary internet.
|
|
#CLIENT: The interface is used to connect clients to the fff-net
|
|
##
|
|
### SPECIFIER
|
|
## For devices only including one ethernet port the specifier is called
|
|
## ETHMODE. The default mode for these devices is "BATMAN".
|
|
## For example this is the case for: gl-ar150, tl-mr3020-v1, tl-wa850re-v1,
|
|
## tl-wa860re-v1, tl-wa901nd-v2, ubnt-bullet-m, ubnt-loco-m-xw, ubnt-nano-m,
|
|
## ubnt-unifi
|
|
ETHMODE="CLIENT"
|
|
## Devices featuring 2 ethernet ports are configured by SPECIFIERs ressembling
|
|
## the labels on the PORT itself. For the cpe210 these are called LAN0 and LAN1.
|
|
## Therefore they are configured as follows:
|
|
LAN0MODE="WAN"
|
|
LAN1MODE="CLIENT"
|